Sanwa – Ricevente 4-ch RX481WP FH4/FH3 Cod.107A41311A

 89,50

Ricevente Sanwa di ultimissima generazione a 4ch waterproof adatta agli usi più estremi come acqua fango neve per la vostra radio professionale .

Esaurito

Sanwa – Ricevente 4-ch RX481WP                                                                                                                           codice articolo 107A41311A

 

 

Sanwa – Ricevente 4-ch RX481WP

商品画像

●2.4GHz FHSS4/FHSS3 Spread Spectrum System 4CH
●Super Response (SSR) Mode-Compatible
●Waterproof (IPX4)

Frequency 2.4GHz FHSS4 / FHSS3 Channel 4CH
Nominal Input Voltage 3.7-7.4V Dimensions 21.4×27.6×29.4mm
Weight 10.7g Compatible radio M12S, M12, EXZES ZZ, EXZES Z,
M11X, EXZES X, MT-4S, MT-4,
MT-S, MX-3X, GEMINI X

 

Versione non impermeabile

[NOTA SULL’USO CON LA BATTERIA DEL RICEVITORE (Li-Po 2cell 7,4 V)]

Quando si utilizza la batteria Li-Po per il ricevitore di auto GP e impostare la modulazione del trasmettitore
come FH3 / FH3F, la batteria non funziona correttamente poiché l’impostazione del trasmettitore della batteria non è sicura
è 3,5 V-5,0 V e la batteria Li-Po non può essere impostata.
Pertanto, quando si utilizza la batteria Li-Po, controllare l’ora di funzionamento da soli e
sostituire la batteria al momento opportuno.
Non saremo responsabili per qualsiasi problema relativo alla sicurezza della batteria
con l’uso della batteria Li-Po.
Grazie per la vostra comprensione.

Receiver/Servo Compatible Table

RX-391W RX-371W
RX-37W
SUR SSR SHR NOR SSR SHR NOR SSR SHR SHR NOR – –
PGS SERVOS
SRG SERVOS
Digital ERG SERVOS
SDX / HVS SERVOS
ERS / ERB SERVOSAnalog Servo

Hyper ERG SERVOS
RS-995 / SX-165T
SPEC SERVOS
SX SERVOS
SRM SERVOS

Receiver/ESC Compatible Table

RX-391W RX-371W
RX-37W
SUR SSR SHR NOR SSR SHR NOR SSR SHR SHR NOR – –

● RX-451R is compatible with SSR/SHR mode. RX-451R is NOT compatible with NOR mode
When using SRG/PGS Servos with SSR mode, the servo will be very quick response than using SHR mode
(*1) Automatically set SSR mode binding with RX-451R by M12S, M12S-RS, M12, EXZES ZZ, EXZES Z, MT-4, MT-4S, MT-S transmitter set SHR mode (display SHR on transmitter)

(*2) Automatically set SHR mode binding with RX-451R by M12S, M12S-RS, M12, EXZES ZZ, EXZES Z, MT-4, MT-4S, MT-S transmitter set NOR mode (display NOR on transmitter)

(*3) In case of using 7.2 V compatible servos, transmitter (Without M12S, M12S-RS, M12, EXZES ZZ, EXZES Z, MT-4, MT-4S, and MT-S) cannot work fail safe mode
It set 3.5V – 5.0 V and cannot change range of voltage. Please take care of changing battery in case of using Li-Po battery. We could not gurantee in this case

(*4) Receiver did not compatible with 7.4 V, Please use 6.0 V for the reciever

(*5) SHR/SSR mode only compatible with degital servos. Using with the modes, the analog servos will be broken. Please do NOT use analog servos by the modes

(*6) Cannot use SV-PLUS series on board with receiver

[NOTE ABOUT USE WITH RECEIVER BATTERY (Li-Po 2cell 7.4V)]

When you use Li-Po battery for receiver of GP car and set modulation of transmitter
as FH3/FH3F, battery fail safe do not work since the transmitter setting of battery fail safe
is 3.5V-5.0V and Li-Po battery cannot be set.
Therefore, when you use Li-Po battery, check your operation time by yourself and
replace battery at suitable time.
We shall not be responsible for any trouble about battery fail safe
with use of Li-Po battery.
Thank you for your understanding
Sanwa – Ricevente 4-ch RX481WP